Is possible to select one of these options:ĥ. CAN-BUS information, which displays status of the ECUs connected to the CAN-BUSĭisplays information about the units configured in the vehicle. You can find it in the “ECU Programming / Coding” menu of all control units except the Body control ECU from which is the configuration transferred. Selectively transfer configuration from BCM to an individual ECUįor this purpose use the coding function Transfer configuration from body control module. You can find it in the “ECU Programming / Coding” menu of the Body control ECU. Transfer configuration from BCM to all ECUsįor this purpose use the coding function Transfer configuration to the all control modules.
For this purpose use the coding function PROXI alignment procedure. (ECUs, that are not properly configured according to the CAN proxi status). This function will automatically transfer the configuration to the ECUs, that are EOL and are not proxi aligned. After reconfiguration of BCM ECU - In such case is necessary to transfer configuration from BCM to all control units in the vehicle.Configuration from BCM have to be transferred to the replaced/added control unit. It usually used to solve "blinking odometer" problem.Ĭonfiguration transfer is required in the following cases: It is necessary to transfer new configuration from BCM to the related EOL ECUs. Distribution of central BCM configuration to other ECUs engine control unit not defined in Body Control Module). Body Control Module may reject write request if new data are not valid for the car (e.g. EOL can be set only in installed ECUs.Ĭlick on “Save configuration” button. The EOL control units needs to be proxi aligned (transfer configuration from the Body Control Unit - BCM to the selected ECU), if these ECUs are replaced. Only some of the vehicle ECUs supports EOL. EOL means End Of Line programming/configuration. If you select Installed ECU from the right list, you can use EOL button to set or reset EOL presence in the selected ECU. You can remove the installed ECU by selecting the ECU from the right list and clicking on the left arrow.įrom the list of available ECUs on the left, please select and add control units you wish to install by clicking on the right arrow. Already installed control units are shown with green mark in the “Installed ECUs” column on the right. You can see 2 columns containing lists of ECUs after you run the Vehicle ECUs configuration.
If the ECU is added or removed from the vehicle, it is necessary to run coding function Vehicle ECUs configuration that can be found in “ECU Programming/Coding menu” of Body Control Module (BSI). how many airbags is installed, LHD/RHD, engine type, etc.) General configuration in BCM, where you can change vehicle behaviour (e.g. There are basically 4 functions often confused: 1. Coding is performed form Body computer coding menu. Proxi alignment procedure is used to add/remove control units and functional blocks from vehicle.
0 kommentar(er)
